Aquatec Double Harness for Use With ESO & CDP6800, 24VAC
This double harness is designed for use with the CDP6800-ESO, and allows for circuit completion in tandem with the Transformer, Booster Pump, and Pressure Switch. If adding an ESO to your existing system, we recommend ordering this with the ESO.
Aquatec Transformer for Use With CDP6800, 24VAC
This Aquatec transformer is designed for use with the Aquatec CDP6800 Series Booster Pump. The transformer is rated for 0.8 AMP service, and comes with US plug for 120v/60Hz supplies with output of 24VAC.
Aquatec Pressure Switch & Harness for Use With CDP6800, 24VAC
Aquatec's tank pressure switch is available to turn off the booster pump when the tank is full. It should be mounted in-line, as close to the tank as possible. The normally closed switch is pre-set at the factory for pressure On/Off range of 20-40PSI. It comes with 2 John Guest half cartridges, for either 1/4" or 3/8" tubing.
The switch also comes with a wiring harness for interconnection with your CDP6800 or CDP8800 pump and accessories.
Note: The pressure switch can be field modified to operate as a normally open switch by changing the wire terminal connector from the NC to the NO switch spade contact.
Aquatec Solenoid Shut-Off for Use With CDP6800, 24VAC
The PSO-24VAC Electronic Shut-Off Valve is a normally closed precision solenoid valve that positively shuts off the feed-water. It can be activated by a pressure switch to open and close at desired holding tank pressure. The valve can be used by itself or mounted in-line on the inlet feed-water side pump, and is powered by the pump's transformer. The valve is available with a .062" diameter orifice for low flow applications or a .093" diameter orifice for high flow applications. Recommended flow rates are 0 -.5 GPM.
Aquatec CDP-6800 Booster Pump Package
The Aquatec CDP6800 Booster Pump is a great way to get better water quality, and more of it! The CDP6800 kit contains everything you will need to retrofit your existing RO system.
NOTE: This pump should only be installed on membrane sizes up to 50GPD capacity.